Sealing pump model Technical parameters: Sealing pump Overview: Sealing pump is a new type of powder pneumatic conveying equipment, the use of high-speed gas injection to transport powder material, in the equivalent distance of 450m, height 40m range Use the best. Sealing pump features: simple structure, simple operation, less operation, can continue to send ash, it can automatically adjust the material seal pump output, can be very good to send the effect of ash, gray media to send low pressure, equipment, pipeline valves Should not wear. Model Feed tube diameter (mm) Conveying capacity (m / h) Required air volume (free) (m / min) Required wind pressure (kpa) Motor power Air jet role, so that the air-driven gray ash to the ash library, material seal pump is mainly composed of four parts were nozzle, cylindrical pump, nozzle adjustment device, the bottom of the vaporization device, material seal pump work from the second Part: Part of the kinetic energy of the fan, the other part is the potential energy of the column. Material column height, potential energy, pressure, the corresponding volume on the large, otherwise small. Sealing pump to maintain a certain level of normal work, when a short period of time the amount of electric dust increases under the material seal pump is still working normally the material level height increases naturally, as the material level increases the material pressure Large potential to increase the amount of transportation corresponding to the system until the automatic balance, when the electricity within a short period of time under the charge of the material to reduce the material seal pump is still working properly, the material level is naturally reduced, with the reduction of material height to reduce potential energy to reduce transmission The corresponding amount of small until the system automatically balanced.