[Kitchen area: pots + seasonings, using drawers, baskets] stove area mainly includes large pots, bowls, seasoning cooking pots, so the optional hardware to drawers, baskets, side pull baskets, partitions Mainly. 
The space beside the cooking space is suitable for the use of side-pull baskets to plan and arrange the cruet bottles and jars, which can be conveniently picked up when cooking and increase the efficiency of cooking; or use a rack above the stove top to place seasoning jars. Cross bar hanging soup pot, but also with a paper towel rack, kitchen knife holder, knife and fork soup and so on. 
Sink area: cleaning supplies, matching shelves or baskets. This area is mainly used for cleaning products. Some water purification equipment will be placed here; baskets, drawers, or telescopic shelves can be used. Classified admission. In addition, a few homeowners will also install the trash can under the sink cabinet, but pay attention to the tightness of the trash, so as not to spill the odor. 
“Hang Cabinet Area: Use less items, use pull-down hardware†to develop upwards. It has always been a good way to gain space for storage! However, due to its high position, it is recommended to place items with lower frequency of use. As for the matching hardware, including automatic Lift basket (cabinet), pull-down hardware and so on. Xiao Bian suggested that if there is a large demand for storage capacity and there is plenty of space above, you can select the pull-down hardware or lift the door-type cabinet; if the space is a bit insufficient, you can use the design of the upper and lower folding doors to facilitate access to the contents of the cabinet. . It should be reminded that if basket type hanging cabinets are used, heavy objects should be avoided as much as possible to extend the service life. 
ã€Cabinet area: large objects, use pull basket, flat pumping, flying saucer basket】 Floor cabinets to place large, heavy items mainly; for easy access, can choose to pull baskets, side pull baskets, drawer dividers, Fully-expanded flat pumping and other hardware aids help sort and pick up. Secondly, it is recommended that “heavyweight items†should be placed at the bottom of the cabinet. Items that are lighter and frequently used should be placed near cabinet doors. 
Also, don't forget to use kitchen corners to increase the storage space; use the cabinets that set up the turntable UFO basket, or the rotary corner linkage cabinet, L-shaped corner turntables, etc., so that these sophisticated hardware equipment can help you to use Corner space. After reading Xiaobian's share today, I don't know if you have any idea about kitchen hardware. Finally, let Xiaobian remind you again, don't forget to keep an eye on “this siteâ€! Hardware Accessories
HDMI, known as High Definition Multimedia Interface, is mainly used for transmitting HD audio and video signals.
There are three types of data transmitted by HDMI TMDS (plus Hsync and Vsync count as four) :
1.Preamble (control information) is mainly used to control the Data to be transmitted next, namely Data Island or Video Data
2.Data Island, all kinds of packet information, including audio packet, image packet, etc
3.Video Data, Video pixel Data. HDMI can transmit pixel Data in RGB and YUV formats
4. And Hsync and Vsync
HDMI Source device (HDMI HPD) will Monitor the Hotplug port of the sink device. If the Hotplug is High, it will prove that the device can work, and then read DCC; if it is low, it will prove that the device is disconnected.
The HDMI Sink device should notify the source device that EDID has been changed by pulling the Hotplug down, and the source device will read the new EDID again after the Hotplug is pulled up, which should be more than 100ms.
HDMI provides that the EDID can be read by DCC when the 5V pin of HDMI is powered on, that is, the Hotplug needs to be high, and some Hotplug is directly connected to the 5V
TMDS Clock is the Pixel Clock, the Clock frequency used for a Pixel point. Through TMDS Clock CLK pins transmitted to the receiver, but the receiver is not clear for what TMDS Clock frequency of the sender sent, so you need to through the Phy (Phy is analog to digital conversion section, is different from the ADC, Phy is don't know the sampling frequency, the need to lock frequency and phase lock, detect the exact input frequency) to lock.
Pc Hdmi Input,Hdmi Input Adapter,Hdmi Input Splitter,Hdmi Port On Tv
Tonya Display Limited , https://www.tydisplay.com