When the lamps in our home are used for a long time, there will be problems of one kind or another. At this moment, we must pay attention to the maintenance of the lamps to make the lamps durable. Then the following small series will introduce you to the five skills of lamp maintenance.
First, after buying the lamp, don't be busy installing it. You should carefully look at the lamp's mark and read the installation and operation manual, and then install and use the lamp according to the instructions. Otherwise, danger may occur;
Secondly, replace the aging lamp with the light source parameters provided by the sign, and find that the two ends of the lamp are red, the lamp is black or there is a black shadow, and the lamp is not bright, the lamp should be replaced in time to prevent the occurrence of ballast. Unsafe phenomena such as burnout of the device;
Third, during cleaning and maintenance, care should be taken not to change the structure of the luminaire, and do not replace the parts of the luminaire casually. After the cleaning and maintenance is finished, the luminaire should be installed as it is, and the parts of the luminaire should not be missed or misplaced;
Fourth, the lamps should be strengthened during use to extend their service life. The lamp of the room should always be wiped with a dry cloth, and pay attention to prevent moisture intrusion, so as to avoid the phenomenon of rust damage or leakage short circuit for a long time; the lamp installed in the toilet and bathroom must be equipped with a moisture-proof lampshade, otherwise the service life will be greatly shortened; Lamps installed in the kitchen should pay special attention to anti-smoke, because the accumulation of grease stains affects the illumination of the lamp; the light-colored lampshade has good transparency, but it is easy to stick to the ash, so it should be diligently wiped to avoid affecting the penetration of light; If the luminaire is non-metallic, it can be wiped with a damp cloth to prevent dust from accumulating and hinder the lighting effect;
Fifth, when using the luminaire, try not to switch frequently, because the current through the filament is higher than the current during normal operation at the moment of frequent startup, so that the filament temperature rises sharply and accelerates sublimation, which will greatly reduce its service life. Therefore, it is necessary to minimize the switch of the luminaire.
Disperse Printing Dyes include Disperse Yellow 114, Disperse Yellow 126, disperse yellow H/3GRL, Disperse Red 343, Disperse Cyanine Blue B, Disperse Blue 60:1 etc.
The dyeing appropriate pH value of disperse yellow 114 is for 3 ~ 7, suitable for high temperature high pressure dyeing method and thermosol dyeing method, is not suitable for carrier dyeing and thermosol dyeing appropriate temperature for 2 1 0 ~ 2 2 0 ℃, used for direct printing vinegar fiber fabric and polyester/cotton blended fabric dyeing hot melt.
Disperse Printing Dyes
Disperse Printing Dyes,Disperse Yellow 114,Disperse Red 343,Disperse Cyanine Blue B
TAIZHOU YOUSHENG CHEMICAL CO., LTD , http://www.youshengchem.com