Nowadays, there are more and more customers using floor heating. Because the floor heating has a temperature control system, many customers use the temperature control system to achieve the energy-saving effect of the heating system when using floor heating, but there are some misunderstandings in use:
Misunderstanding 1. Some customers open the thermostat when someone is in order to save power. When not in use, the thermostat is turned off. In fact, this is wrong. The electric floor heating system is a low-temperature operation system. Since the general heating cables are laid in the concrete, the concrete needs to be heated first to heat. Therefore, the heating cable floor radiant heating system has good heat storage, and in this case, the use effect of the floor heating system has a hysteresis. That is to say, it takes a certain time after the system is turned on to make the temperature of the room reach the set temperature, and the temperature of the room does not fall rapidly after the system is turned off, and it takes a long time to lower the temperature. This not only fails to achieve the energy-saving effect of the floor heating system, but also increases the operating cost of the heating system. At the same time, frequent opening or closing of the heating system will also reduce the service life of the floor heating system.
The correct way: the room that is not commonly used can lower the temperature by a few degrees. When leaving the house for a long time, you only need to lower the temperature of the thermostat by a few degrees. You can choose the relationship system if you don’t stay for a long time or leave for a long time. However, it should be noted that if the room has equipment or the pipeline is afraid of freezing, it is still necessary to turn on the duty temperature to prevent the equipment or pipeline from freezing. Misunderstanding 2, set the high temperature to warm up Some users feel that the room temperature is low, need to quickly heat up to set the temperature of the thermostat to the highest, this practice is also wrong. The temperature rise time of the room depends on the indoor and outdoor temperature difference and the installation power per unit area of ​​the room. In the case of a fixed installation power and a constant temperature difference between indoor and outdoor, no matter how many degrees you set, the room will rise to the same temperature you need. If your room is now 16 ° C, you want to warm the room to 18 ° C, here In this case, you set the temperature to 18 °C and the time you set 20 ° C or even 25 ° C to 18 ° C is the same. The correct way: how many degrees to set, or use a smart thermostat, the thermostat can automatically calculate the thermostat early opening time.
Misunderstanding 3. All temperature control is the same. Many users set the temperature according to their own room temperature, but they can't reach the set heating effect after the temperature is set. In fact, the temperature controller is divided into ground temperature type, room temperature type and double temperature type according to the detection method. The geothermal temperature controller detects the ground temperature to control the ground temperature; the room temperature thermostat detects the indoor air temperature to control the indoor temperature; the dual temperature thermostat controls the indoor temperature under the condition of controlling the maximum temperature of the ground. The ground temperature cannot be adjusted, but some good thermostats can set the maximum temperature of the ground temperature. These thermostats are not very different in appearance and are prone to misunderstanding. The ground temperature and the indoor temperature are different. When setting the temperature, it is necessary to distinguish the temperature temperature controller and the room temperature thermostat. Generally, the temperature setting of the temperature controller is higher than the setting temperature of the room temperature thermostat. If the temperature controller is used. According to the room temperature thermostat, the room will not be hot.
The correct approach:
When setting the temperature, determine the model of the thermostat and set different temperatures according to different models of the thermostat.
The temperature control system is the key to the energy-saving operation of the floor heating system. Regardless of the nature of the floor heating system, the relevant specifications should be observed when using it. Do not affect the heating effect of the floor heating system due to wrong use.
Swimming Pool Pump
Shenzhen Poolux Lighting Co., Ltd. , https://www.pooluxled.com