 Ott House Art Wall Â
Glass brick partition wall construction points:
1. Glass bricks should be built on the basis of two reinforced f6-f8 reinforcements. The base height should not exceed 150mm and the width should be more than 20mm above the glass brick thickness.
2. For the application of metal profiles at the top and the ends of the glass brick dividing wall, the width of the bad mouth should be greater than the thickness of the brick 10~18mm.
3. When the length or height of the partition is greater than 1500mm, install a steel bar in every second layer in the vertical direction (when the length and height exceed 1500mm, set two steel bars); set a steel bar every three vertical seams in the horizontal direction. . Rebar extends not less than 35mm into the slot. The height of glass blocks reinforced with reinforced steel shall not exceed 4m.
4. The two ends of the glass partition wall and the two sides of the metal profile shall have a sliding joint with a width of not less than 4mm, and the joint shall be filled with linoleum; the glass partitioning plate and the ventral side of the profile shall have expansion joints with a width of not less than 10mm to avoid the glass brick partition wall. damage.
5. The top layer of glass brick should extend into the top metal profile slot 10 ~ 25mm, so as to avoid broken glass block due to rigid extrusion.
6. The joint between glass bricks shall not be less than 10mm and not more than 30mm.
7. The joints between glass bricks and profiles, profiles and buildings shall be sealed with elastic sealant.
Wall construction glass glass brick
Shenzhou Yuye Housewares Co., Ltd. , http://www.fscurtainrod.com