01. The surface is flat. The deviation is less than or equal to 1.5mm.
02. The color and pattern are basically the same.
03. The interface is flat and the corners are firmly bonded. The deviation is less than or equal to 0.5mm.
04ã€All-purpose adhesives must use qualified brands with tight seams.
05, no exposed caps, nails, no hammer marks.
06, 2.2m within the line plate installation should not have connectors, joints flat, consistent color.
07, baseboard, straight down the top corner line. The deviation is less than or equal to 3mm.
08. The baseboard is closely connected with the floor. The skirting board is flush with the wall and is seamless. The deviation is less than 3mm.
09, wooden skirting should be set on the side of the deformation tank, groove depth 3-5mm, width 10mm or so.
10. The distance between the center of the embedded wooden pillow in the wall should not exceed 300mm.
11. No nails (foots) shall be left on the surface. The nail cap shall be flattened and knocked into the depth of 0.5-1mm or nailed with a nail.
12, in the construction sequence, the skirting board should be set after polishing the floor.
13. The surface is smooth and flat, and it is closely connected with the floor (tiles). The top edge is straight and close to the wall. The thickness of the wall is the same and the joints are tight. The deviation of the full-length is less than 3mm.
14, the back of the wooden baseboard should be painted once again varnish.
15. The length of the baseboard of the veneer collage type baseboard should be 1.22m; the space between the baseboards should be 3mm.
Baseboard installation decoration construction knowledge paint floor tiles
H Shape Post,V Shape Post,Mushroom Shape Post,Rectangle Post
Anping Xinlong Wire Mesh Manufacture Co.,Ltd. , https://www.xinlongfence.com