I believe friends all know that the bathroom is an area with a lot of water consumption, so when carrying out the room decoration, the waterproofing project is often a very important part. Of course, whether it is material selection or the implementation of the engineering waterproofing project, it will be in daily life. There are hidden dangers, so how to make the bathroom waterproof is a problem that everyone attaches great importance to, so what are the steps to make the bathroom waterproof? Let's take a look with the editor.
Toilet waterproof steps
1. Organize walls
During construction, first make sure that the ground and walls of the area are clean and dry, so it is necessary to do good hygiene in advance, so as to ensure that it is fully covered when the paint is applied later, so this Must not be ignored.
2. Waterproof coating
Generally speaking, the paint needs to be applied twice, but there must be a certain interval between them, especially after the first pass, make sure that the paint has dried up and then apply the second pass, of course, this should also be Judge according to the actual situation.
3. Lay a protective layer
Many users think that the entire process will be completed after the paint is applied. In fact, it is not. Such products cannot withstand the destruction of time. Therefore, after the paint is dried, it is necessary to lay a waterproof protective layer on the top. Pay attention to protection All the layers should cover the waterproof layer completely, without any omission.
4. Closed water test
In fact, this is a check method. During operation, the water level at the highest point on the ground should not be lower than 2CM. If there is still no water leakage in 24 hours, it means that the waterproofing is done. If there is water leakage, it means that the waterproofing Redo.
What is the waterproof height of the bathroom
1. Wall waterproof height
Generally speaking, the wall needs to have about 30cm of waterproof paint. If it is insufficient or exceeds too much, then it does not meet the requirements. However, if the bathroom wall is a non-load-bearing light-weight wall, then the waterproofing needs to be used. Water-repellent paint fills the entire light-weight wall so that it can be truly waterproof.
2. Waterproof coating height
Please pay attention when painting, it is not just to apply a few times. In construction, it is necessary to comply with certain requirements. For example, the thickness of the waterproof coating film is required to be more than 1.5 mm. If required, repainting is required, and it should be noted that the paint that has been brushed must be repainted in a large area after drying at room temperature, and there must be no leakage or bubbling.
Summary: Ok, the above is about the analysis of the waterproof steps of the bathroom . I hope to provide you with some help. I believe that in the future of the bathroom , the friends will be more handy and create their own satisfactory results.
What, the decoration still uses his own money? ! The Qi family is decorated in installments, with an ultra-low annual interest rate of 3.55% and a maximum loan of 1 million. Apply now to enjoy the discount
Black Face Mask, Black Mask, Face Mask, Disposable Face Mask, Protective Mask
Shandong Shengquan New Materials Co., Ltd. , https://www.sqnewmaterials.com