First, the disinfection of the fill. When the mushroom wall is cultivated, the soil must be cleaned and disinfected before use. Filling should be prepared in two ways: 1. For the purpose of sealing, choose a soil with a thicker viscosity to prevent the bacteria wall from leaking. 2, for internal filling, you must choose fertile garden soil. No matter which kind of soil, it should be excavated under the surface of 10 cm below the ground, and exposed to sunlight for 3 to 4 days, then add 1% lime, 0.1% carbendazim and mix and disinfect, for internal filling of nutrient soil. Add 0.5% phosphate fertilizer, 0.3% urea.
Second, the bacteria bag should not be too long. The length of the bag is 25 cm long.
Third, the bacteria wall. Do not take off the bag wall when the bag is just full of hyphae. It should be re-base after the yellow water is discharged (to reach physiological maturity) or when the original base is formed. When the wall is built, the physiological maturity is consistent, so that the mushrooms are neat and easy to manage.
Fourth, hydration. According to the physiological needs of Pleurotus ostreatus and the dry and wet conditions of soil and materials, timely and appropriate amount of water should be replenished. The water content in the pre-bacterial bag should be less, so that the soil moisture can reach 20%. After picking a mushroom, you can make up 1 big water (should be done after a few days of stopping water and nourishing). Note that the hydration should not be too strong and leakproof.
5. Adjust the humidity of the air and material surface. After the pre-production of the mushroom, not only the water should be replenished into the wall, but also the air should be humidified to keep the surface moist. And keep the air humidity at around 80%.
Insulation stop valve: BJ41W, BJ41Y, BJ45H, BJ45Y, BJ45W
Forged steel globe valve: J61Y, J61H, J41H, J11H
Bellows globe valve: WJ41H, WJ41Y, WJ41W
Instrument needle globe valve: J13, J23
Cryogenic globe valve: DJ41Y, DJ41W
Water seal globe valve: DS/J61H
Oxygen special shut-off valve: JY41W, JY41Y
Gas shut-off valve: J41N
Plunger stop valve: J40HX-16G
Stainless steel globe valve: J41W
External thread globe valve: J21H, J21W
External thread stainless steel globe valve: J21W-16C6L
American standard globe valve: J41H, J41Y, J41F
Bevel gear globe valve: J541Y, J541H, J541W
Electric globe valve: J941Y, J941H, J941W
Fluorine-lined globe valve: J41F46
National standard globe valve: J41H, J41Y, J41F
Throttle stop valve: FJ41
Globe Valve,Ball Valve,Check Valve,Butterfly Valve
Rugao Yaou Import & Export Trade Co., Ltd , https://www.ntyaoumachinery.com