The power must be cut off during installation to ensure safety.
Verify that the wiring port is correct before powering up.
If it is found that the work is abnormal (self-extinguishing, flashing), the power should be turned off immediately and removed by a professional. .
The bottom of the bulb (coupler base) and the fixture of the luminaire must be firmly connected and in close contact to ensure good heat dissipation.
The shield between the lamp and the HF generator must not be lengthened or shortened.
The bulb and HF generator are required to be grounded separately during installation.
The luminaire housing must be grounded regardless of the luminaire used.
The light source should not be lit for more than 15 minutes when it is not connected to the luminaire (the lamp itself acts as a heat sink).
When the bulb is lit or just turned off, do not touch the bulb directly with your hand to avoid burns.
The coupler and HF generator cannot be changed at will.
Both the induction lamp and the high frequency generator cannot be mounted on a luminaire without a heat sink.
Occasionally, the electrodeless lamp does not illuminate, or it turns off after lighting. Please check the heat sink of the lamp.
If the generator is installed in a closed electrical box, the top cover of the generator can be removed.
Threaded rods, also known as tooth bar, Screw, full thread stud, etc., has no head, and is a fastener with full thread on the threaded post and guide angle at both ends. It is generally used as the connection between thicker parts and is mostly used for fastening in the mechanical industry.
Threaded Rod,Threaded Bar,All Thread Rod,Lowes Threaded Rod
Jiangsu Jiajie Special Screw Co., Ltd , https://www.jiajiescrewcompany.com