In the end, what kind of material is the stone protective agent? How to do the protective treatment to get the most effective effect? ​​At which stage of the stone processing, the protective treatment can meet the maximum economic benefit. Which installation method can avoid a large number of lesions? Infringement of the stone maintenance problems currently faced by the stone and stone industry, most of them are lesions after installation. When all aspects seek the cause of stone problems, the focus is often on whether the stone installers use unqualified stone, whether the stone installer cuts the work order, and whether the stone construction method is appropriate. These are all issues that everyone should pay attention to!
At present, the most commonly used method in China's stone processing plants is to apply a layer of wax on the surface of the finished stone, which can increase the surface gloss of the stone finished product, and reduce the chicken claw pattern on the stone surface. The wax is a surface protective material. When it is covered on the surface of the stone, the original pores and fine lines on the surface of the stone will be blocked. Therefore, if the stone installer or the stone protection industry wants to carry out the stone protection work, the wax already existing on the surface of the stone instead It is the biggest obstacle in the interior of the stone, and the protective layer only exists on the surface and cannot penetrate below the surface of the stone. It may cause the protection failure and the risk of subsequent lesions to increase, which is for consumers and construction installers. It can cause great trouble. In this case, if the floor stone is paved with a soft bottom wet construction method, the stone to be laid is often a less dense material (such as light-colored granite), and local water spot lesions occur after the base water contains water. It is almost inevitable. In addition, many waxed stones are exposed to air and sunlight for a long time, which is prone to yellowing. It may also be the primary factor for yellowing of stone.
In fact, from a chemical point of view, the proportion of failures in wax removal projects may be higher than the probability of success. This can be compared with the first aid for human poisoning by doctors. The chemical composition of wax must be clearly analyzed and the drug must be taken into account. It is actually a difficult thing to damage the stone itself without toxicity. Moreover, it is almost unrealistic to require the stone protection industry to have a complete background in chemical education.
In response to the above problems (protection after stone waxing), some stone protection companies will use the wax removal procedure to clean the stone surface. However, the effect is often not as good as expected, mainly because it may be wax removal. The effect of the agent is not good. There are too many kinds of waxes, and the waxes currently used on the surface of building materials are not limited to dozens of resins, acrylics, silicones, etc., and non-resin hard acetic acid, oleic acid, white wax, etc. The nature and physical characteristics are different. Therefore, it is not easy to find a wax removing agent which can be applied to each wax.
Jiu Zheng Xiaobian suggested: manufacturers engaged in stone processing should not use wax as the quality improvement material for stone surface, but should consider the use of protective agent as the material for improving the surface quality of stone, in order to avoid hindering the protection project of stone later, it is not difficult It is found that the problem of stone lesions that may be generated by the stone processing factory in the waxing of the stone surface is actually extremely significant. In this case, it can effectively reduce the probability of stone problems and eliminate consumers' doubts about the use of stone.
[Scan the QR code below, pay attention to the WeChat public number "Jiuzheng Stone Net "; you will receive the latest stone news, information, business opportunities! What are you waiting for? Join the China Building Materials First Network - Stone Group: 65406142]
Bx Ring Joint Gasket ,Bx 155 Ring Gasket,Bx Ring Gasket,Bx 154 Ring Gasket
WENZHOU JINGWEI SEAL TECHNOLOGY CO., LTD , https://www.ringjoint-gasket.com