For the comfort of the foot, many homeowners will choose to apply wood flooring. What are the procedures for laying floors ? Next, let's take a look at the related description of the procedure for paving the floor through the following content.
Procedures for laying floors 1. After the ground has been cleaned and leveled, lay a layer of moisture-proof floor mat (not necessarily under the wood on the wooden floor). This layer should be at least 20-30 cm (about 8 inches) in the gap about 1-3 inches away from the wall. You can now install the floor that has been selected. It should be noted that the laid moisture-proof floor mats only need to lay approximately 5-10 rows of floor.
Procedures for laying the wooden floor 2. Directly frame wooden frames (commonly known as wooden joists) according to the ground bouncing. The cross-sectional size of the wood frame body is 30mm'40mm or 40mm'50mm, and the connection method is half-groove fastening, and glue and nail are applied at the buckle joint. After that, use an impact drill to drill a hole in the wooden frame and the ground, fix it with the bolt to the ground, and check whether the frame is kept horizontal.
Procedures for laying the floor 3 , the first row of the remaining boards are usually used at the beginning of the second row, to ensure that the interface between the interface of the second row of boards and the interface of the first row of boards is at least 30 cm (1 foot) in length and will be lowered Insert a plate into the groove in the second row and place it horizontally.
The procedure 4 of laying the wooden floor and the next board are installed on the already installed floor according to a certain angle, and it is necessary to ensure that the longer side of the floor is combined with the upper row of boards as closely as possible.
The procedure for laying the wooden floor 5 is to be tested by the elastic line. The core of the wooden board faces upwards and the sapwood faces downwards. The width between the board and the board is not more than 1 mm. It is numbered after repeated adjustments, and it is paved along the middle of the ID room in the middle of construction. When paving to the foot of the wall, leave a space of a wide width. Place a wooden block on the empty space and hold it against the water floor. Tighten the wooden wedge of the top tight block at the beginning to tighten the floor.
The procedure for laying the wooden floor 6 , using a round nail with a length of 2 to 2.5 times the thickness of the wood board, flattening its head, and diagonally inserting it from the concave corner of the board. If it is a hard wood board, drill a hole with a diameter smaller than the round nail by hand with a drill to prevent the needle from cracking the wood floor.
The procedure of laying the wooden floor 7 , after sweeping the floor clean, press the vertical wood grain first to plan the rough plane again, and then follow the direction of the wood grain to make a plan, and then polish it. The total thickness of screed does not exceed 1.5mm.
Procedures for paving the wood floor 8 , removing the top tight blocks around the floor, performing floor side trimming, collecting long wooden bars, and wooden floor bars.
The procedure of laying the wood floor 9 , after the floor is polished, paint, dry and wax.
With regard to the procedures for paving the floor , I will introduce it to you. I hope to help you, and more information on the decoration will be provided on this site. Please stay tuned.
Wooden Flooring How to Choose Bamboo Flooring Good or Wooden Flooring Good Wooden Flooring Flooring Hot Wood Flooring Bathroom Wood Flooring
Submersible Pool Led Lights,Waterproof Led Lights,Underground Pool Led Lights,Concrete Pool Light
Guangzhou Qshine Pool Lights Manufacture Co., Ltd , https://www.qshinepoollight.com